Location And Function Of Parts; Front Panel - Sony HKCU-IP43F Operation Manual

Location and Function of Parts

Front Panel

1 2
8
a Red tally indicator
Lights in red when this unit receives a red tally signal. You can
attach the supplied number plate here.
b Yellow tally indicator
Lights in yellow when this unit receives a yellow tally signal.
c Green tally indicator
Lights in green when this unit receives a green tally signal.
d CCU number display
Displays the camera number set in the CCU menu.
e NMI STATUS indicator or NETWORK indicator
• NMI STATUS indicator (when HKCU-IP43F is installed)
Displays the NMI-LAN status.
Green: Normal status
Flashing green: Network synchronization in progress
Off: SFP+ module is not installed.
Disconnected from IP Live System Manager.
Connection with IP Live System Manager in progress
Flashing red: Not locked to network sync signal.
Signal reception is unavailable.
3
4 5 6
9 0 qa qs
7
qd qf
• NETWORK indicator (when HKCU-4001 is installed)
Displays the GENLOCK status of the network.
Low-speed flashing: PTP master not detected
High-speed flashing: Genlock initiated
Lit: Genlock achieved
Not lit: Network genlock setting disabled
f Status display indicator
REF IN (green): Indicates presence of REFERENCE input
signal.
UNLOCK (Red): Not locked to the REFERENCE input signal.
NETWORK or RCP/MSU (when HKCU-4001 is installed):
Displays the status when there is a network system
connection.
On: When CNS MODE on the <CNS SETTINGS> page in
the NETWORK menu is set to either BRIDGE or
MCS, this indicates that external control equipment
(MSU-1000/1500 Master Setup Unit, RCP-3000/
1000 series Remote Control Panel, or other
equipment) is connected.
Flashing: When CNS MODE on the <CNS SETTINGS>
page in the NETWORK menu is set to either BRIDGE
or MCS, this indicates that the unit cannot connect
correctly with external control equipment (MSU-1000/
1500 Master Setup Unit, RCP-3000/1000 series
Remote Control Panel, or other equipment).
Off: When CNS MODE on the <CNS SETTINGS> page
in the NETWORK menu is set to either BRIDGE or
MCS, this indicates that a LAN cable is not connected
or that the network system connection settings have
not been configured.
When CNS MODE on the <CNS SETTINGS> page in
the NETWORK menu is set to LEGACY, this remains
turned off.
COM ERROR (Red): Communication with the camera or
external control equipment (such as the RCP-3000/1000
series Remote Control Panel) is not possible.
FAN STOP (Red): The fan is stopped.
7