Sony HKCU-IP43F Operation Manual page 51

AUDIO/INTERCOM
Page name Item
Page No.
<INTERCOM> INTERCOM CH
A03
PRODUCER
INTERFACE
ENGINEER
INTERFACE
PGM1 INPUT
PGM2 INPUT
<FRONT INTERCOM> MIC/PGM
A04
I/F
PRIVATE SW
INTERCOM MIC
INTERCOM MIC
TYPE
INTERCOM MIC
GAIN
SIDE TONE LEVEL
PGM MIX MODE
PGM SEL
PGM1 LEVEL
PGM2 LEVEL
Set value
1CH(PROD), 2CH(PROD&ENG)
CLEAR COM, 4WIRE, RTS
SIDETONE –99 to 99 0
CANCEL
TERMINATION OFF, ON
CLEAR COM, 4WIRE, RTS
SIDETONE –99 to 99 0
CANCEL
TERMINATION OFF, ON
–20, 0, +4 dBu
–20, 0, +4 dBu
(PGM ON), (MIC OFF), (MIC ON)
(PROD), (ENG), (PRIV)
ENABLE, DISABLE(SET TO
ENG), DISABLE(SET TO PROD)
DYNAMIC, ECM, CARBON
BALANCED, UNBALANCED
–6, 0, +6 dB
0 to 99, 50
OFF, INCOM+PGM, L-INCOM/
R-PGM
PGM1, PGM2, PGM1+PGM2
0 to 99, 50
0 to 99, 50
Description
Selects the intercom channel number to be used.
Sets the producer line intercom system.
Sets the side tone cancel level. (Setting is possible
when CLEAR COM or RTS is selected)
Sets termination resistance (200 ohms). (Setting is
possible when CLEAR COM or RTS is selected)
OFF: Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the engineer line intercom system.
Sets the side tone cancel level. (Setting is possible
when CLEAR COM or RTS is selected)
Sets termination resistance (200 ohms). (Setting is
possible when CLEAR COM or RTS is selected)
OFF: Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the PGM1 input level of D-sub connector on
rear panel.
Sets the PGM2 input level of D-sub connector on
rear panel.
Front panel MIC/PGM switch position (Display only)
Front panel INTERCOM operation status (Display
only)
Operation when the INTERCOM switch on the front
panel is set to the PRIV position.
ENABLE: Private operation
DISABLE(SET TO ENG): Same function as ENG
position.
DISABLE(SET TO PROD): Same function as PROD
position.
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
CARBON: Carbon microphone (power supply, 20 dB
gain)
ECM: Electret condenser microphone (power supply,
40 dB gain)
DYNAMIC: Dynamic microphone (no power supply,
60 dB gain)
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
BALANCED: Balanced microphone
UNBALANCED: Unbalanced microphone
Sets the microphone input gain.
Sets the side tone level.
OFF: Signals are not mixed.
INCOM+PGM: INCOM and PGM signals are mixed.
L-INCOM/R-PGM: Outputs INCOM signal through
the left channel and PGM signal through the right.
Selects the PGM audio output from the FRONT
INTERCOM connector.
Sets the MIX level of PGM1.
Sets the MIX level of PGM2.
51