Mounting Instructions; Preparation Before Installation - Mitsubishi Electric VL-50S2-E Installation Manual

5. Mounting instructions

5.1. Wall-hole construction
5.1.1. Determine the installation
position.
1. Check the necessary space distance.
Vertical mounting
positioned properly to secure the mounting
supporting structure.)
2. Mark the center of the wall hole position.
Note
Make sure that the mounting surface of the
noise or the shutter could not operate properly.
5.1.2. Drill the wall holes.
Inside
Note
Make the holes so they slope down as they
exit the outside wall.
rainwater.
* Nothing should obstruct
(Do not place anything
Unit (mm)
D
193 182
182 193
2°
Outside
Eng-5
5.1.3. Pull out the power and
connection cables.
For VL-50ES -E only
2
1. Determine the power and connection cable
mounting position diagram on page 4.)
2. Pull out the power and connection cables on
the indoor side.
Note
For VL-50S -E, attach a power outlet within
2
the range where the power plug can be
connected (the effective cable length is
about 3 m).

5.2. Preparation before installation

5.2.1. For horizontal mounting
1. Attach the packing to the pipe mounting
plate.
Put the packing (included in the package) in the
mounting plate.
mark side.
"シタ" mark
2. Apply caulking compound.
plate.
Power and connection
cables
Power and
connection cables
Packing
Pipe mounting plate
Packing