Electrical Work - Mitsubishi Electric VL-50S2-E Installation Manual

4. Press the main unit into the wall and attach
it with the four screws provided.
mm or longer.
Unit
screw
Drain pan end
*
Note
the main unit is hung has been temporarily
secured, thus always support the main unit
with your hand and tighten the screw.

5.4 Electrical work

Warning
Use at the rated voltage.
Connect wires securely to terminal block
connections so they do not come out.*1
Electrical work must be done by an electrical
contractor (a licensed electrician) in
accordance with the technical standards of
the equipment and local regulations to ensure
safety.
*1 :
2
For VL-50ES -E
2
Note
Check that the unit operates correctly.
timers controlled by semiconductor, are used.
Mounting
plate
2
Power and connection
cable
Ground cable
Ground screw
Eng-10
Operation requires a control switch. Have a
control switch ready and connect the wiring
shown in bold on the connection diagram below.
of the power and connection cables and
screw the ends in place on the terminal
block.
COM
Hi
Lo
ground with a ground screw to ensure the unit
is grounded.
with the cord clamp.
(4) Make sure that the wires have not come
position.
5.5 Attaching the panel
1. Attach the wire of the panel (fall prevention)
to the hook of the unit.
Unit
Isolator
Hook
Panel