Section 3:Operation; Operation And User Interface; Home Screen; Selecting System Modes - Generac Power Systems PWRcell XVT076A03 Owner's Manual

Section 3: Operation

Operation and User Interface

See 3-1. Generac PWRcell is controlled through
Figure
the PWRcell inverter control panel. The inverter control
panel is used for adjusting system settings and for
interacting with devices.
•
Use left and right arrows (A) to navigate between
pages.
•
Press center button (B) on a device page to modify
device settings.
A
Figure 3-1. Inverter Control Panel

Home Screen

See Figure 3-2. The power flow display on the home
screen illustrates the flow of power in the system. As
power is generated, stored and consumed, animated
arrows indicate the flow and direction of power. System
AC and DC voltage levels are displayed near the center
of the screen. The current system mode is displayed at
the top of the screen.
Figure 3-2. Home Screen

Selecting System Modes

Once a system is installed, a system mode that best suits
the user's needs must be set. Once set, the system
remains in that mode without needing to be changed.
Owner's Manual for Generac PWRCell Inverter
NOTE: A system mode can be changed at any time.
To select a system mode:
1. See Figure
press the center button.
B
Figure 3-3. Selecting System Modes (1 of 5)
2. See Figure
displayed with the current mode marked with an
asterisk.
NOTE: The list of modes may not include all those
009894
shown in Figure
System Mode
Safety Shutdown
Grid Tie *
Self Supply
Clean Backup
< EXIT
Figure 3-4. Selecting System Modes (2 of 5)
3. See
Figure
highlight the desired mode and press the center
button to select it.
009965
3-3. While viewing the home screen
3-4. A list of system modes will be
3-4.
SCROLL > NEXT • SELECT
3-5. Use the up and down arrows to
Operation
009965
Menu
009966
13