Tektronix TDS2000C Series Manual page 11

Check Signal Integrity (continued)
The TDS2000C Series' automatic measurement system can also be
used to make such measurements quickly and automatically.
TDS2000C Series Oscilloscope
To make signal integrity measurements using
automatic measurement system:
1. Press the MEASURE front panel button.
2. Press a CH1 side menu button to add an automatic
measurement.
3. Press the Type side menu button until you find the desired
measurement, and then press Back.
4. Repeat steps 2 and 3 to select and display up to 5
measurements.
5. View the selected measurements on the right side of the display.
www.tektronix.com/tds2000
11