Crown CT29002HX Original Instructions Manual page 23

• Switch on the power tool�
• Perform the blowing operation�
Using for dust collecting operation (see fig. 2)
Do not use the power tool as a vacuum
cleaner without a dust bag 15.
• To use the power tool as a vacuum cleaner, attach
nozzle 1 and the dust bag 15 as shown in fig. 2.1.
• Switch on the power tool�
• Perform the suction operation�
Attention! Do not use the power tool as
a vacuum cleaner for collecting solid
objects (such as nails, steel cutting
waste, stones, glass fragments, etc).
Steady-state using (see fig. 12)
• Perform assembly
above�
• Push on / off switch 8 and lock it in this position with
lock-on button 7�
• Install the power tool on the even horizontal
surface�
• Perform the operation (see fig. 12).
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool
remove the battery 13.
Battery maintenance instruction
• Charge timely before the battery 13 is completely
exhausted� Stop operation in low power and charge it
immediately�
• Do not overcharge when the battery 13 is full, other-
wise it will shorten the life time�
• Charge battery 13 in the room temperature of 10°C
to 40°C (50°F to 104°F)�
• Charge battery 13 every 6 months without operation
for a long time�
• Replace worn out batteries in time� Decline of pro-
duction or a significantly shorter runtime of the power
tool after charging indicates aging of the battery 13
and the need for replacement� It should be taken into
account that the battery 13 may discharge faster if
the works take place in the temperature below 0°С.
• In case of long time storage without use, it is recom-
mended to store the battery 13 at room temperature, it
should be charged to 50%�
The manufacturer reserves the possibility to introduce changes.
operations as described
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots 9�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com�
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Li-Ion batteries
The contained Li-Ion batteries are subject to the Danger-
ous Goods Legislation requirements� The user can trans-
port the batteries by road without further requirements�
When being transported by third parties (e�g�: air trans-
port or forwarding agency), special requirements on
packaging and labelling must be observed� For prepa-
ration of the item being shipped, consulting an expert
for hazardous material is required�
Dispatch batteries only when the housing is undam-
aged� Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move around
in the packaging� Please also observe possibly more
detailed national regulations�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging
should be sorted for environment-friendly re-
cycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
English
23