Nortel Business Communications Manager 2.5 Programming Manual page 139

Priority> 221
BLOCK
Release a call
Use line pool?
YES NO
Hold or release
Release calls
Line in use
No button free
Make calls first
No free lines
No line selected
In use:221
Common display prompts and error messages
You are receiving a priority call. If you are on another call, tell the
person you are speaking to that you are about to put the call on
hold. Press the flashing line indicator of the priority call or wait
until the call connects automatically (in eight seconds). The
priority call goes through after you hear the next beep. Your active
call is on Exclusive Hold. It reconnects automatically when the
priority call ends (unless you transfer the priority call, in which
case you must press the line button of your original call to
reconnect). Use DND (≤°fi) or press
priority call.
You have no free line available to receive a call. Release one of
your current calls and try again to answer the incoming call.
You received a Ring Again offer for a line pool. Press the flashing
internal line button or
telephone, lift the handset. Otherwise, press
for the Ring Again offer to expire.
While on a call, you must either release the call or put the call on
hold before you can program a feature button.
You tried to use a feature while you were on a call or had calls on
hold. Release the call or calls, before using the feature.
The line is in use. Make the call using normal methods or wait
until a line is free.
You tried to make, receive or pick up a call when no line button
was available. Some features require you to have a button free.
Releasing calls can free up line buttons.
The feature you tried to use requires you to be on an active call at
your telephone. This prompt also appears when information about
a call is cleared by a system reset.
All the lines or line pools available to the telephone are in use.
This prompt also appears when you try to dial an external number
or use a feature that conflicts with the lines, line pools or prime
line used by the telephone. Your installer must correct this
situation.
The telephone is set up to dial an external number on a prime line
but the telephone does not have a prime line. Your installer must
correct this situation.
You tried to program redirection while the feature is in use. Only
one person can program line redirection at a time.
YES
to use the line pool. On the T7100
NO
Telephone Features Programming Guide
BLOCK
to reject a
or wait 30 seconds
139