FabiaTech FB2530 Series User's Quick Setting

Version 1.3
1. Brief
The FB2530 is an all-in-one, 3.5" disk size, NS Geode low power CPU board. This user's quick
setting provides the jumper settings, connector location, and their pin assignment.
2. Board Placement
J1 CN3
JP1
J3 CN4
JP2
BUS1
J4
JP3
JP4
JP5
J2
CN1
CN2 DB1 J7
3. Packing List
1 FB2530 all-in-one CPU board.
1 44-pin hard disk drive interface cable.
1 20-pin to 34-pin floppy drive interface cable.
1 serial port adapter cable and 1 parallel port interface cable.
1 PS/2 keyboard and mouse port adapter cable.
1 audio adapter cable with FB4612B transfers board.
1 6-pin power adapter cable.
1 compact disc includes software utility.
1 hard copies of this quick setup manual.
FB2530 Series User's Quick Setting
CN6
J6
J8
J5 CN8
JP6
CN5
CN7
JP7
CN9 CN10
DB2 LM1
4. Features
* On-board 200~300 MHz NS Geode GX1 CPU.
* NS CS5530A chipset with UMA architecture.
* 1 So-DIMM socket for up to 128MB PC-100 SDRAM.
* One or two 100/10 base-T Ethernet ports.
* Provides CRT and LCD with 1.5MB to 4MB shared memory.
* 1 parallel port, 1 RS-232, 1 RS-232/485/IrDA.
* 1 floppy port and 1 PCI IDE interface.
* PS/2 compatible keyboard and mouse interface.
* Provides header for external speaker.
* Flash BIOS with easy upgrade utility.
* AC97 audio function supports Line-In, Line-Out, and Mic-In.
* 2 USB ports and software programmable watchdog timer.
* 2 TTL input lines and 2 TTL output lines.
* Power requires +5V - 1.3A maximum, +12V - 0.1A maximum.
* 3.5" disk size, 145 mm x 102 mm (5.7" x 4.0")
5. Connectors, Headers and Their Relative Jumpers
A. Reset Switch (J7)
J7 is a push bottom switch for system reset. Push and release the bottom will cause hardware
reset of FB2530 and restart system booting.
B. Power Connector (J6: 6-pin 2.5mm JST)
J6
6
C. Keyboard and Mouse Connector (CN1: 6-pin 2.0mm JST))
CN11
CN1 provides PS/2 keyboard and mouse interface, use the included adapter cable to connect
between CN1 and standard PS/2 devices.
CN1
D. Serial Port Connectors and Jumpers
The serial port1 supports RS-232 only and the serial port 2 supports RS-232, RS-485 and
InfraRed interface. JP6 is used to select RS-232 or RS-485 of serial port 2 and JP3 provides
terminator select of RS-485 mode. Both ports also provide jumper for power output selection.
Pin 1: Ground Pin 4: Ground
Pin 2: +5V Pin 5: Ground
Pin 3: +5V Pin 6: +12V
1
6 Pin 1: Mouse Data
Pin 2: Keyboard Data
Pin 3: Ground
Pin 4: +5V
Pin 5: Mouse Clock
1 Pin 6: Keyboard Clock
(DB1, CN2, J2, J4, JP3, JP4, JP5, and
Page 1/3
JP6)
©2001-2002 FabiaTech Corp.