Crossover Frequency - Sony STR-DA4600ES Operating Instructions Manual

To adjust the distance from the
seating position to each
speaker
You can adjust the distance from the seating
position to each speaker (front left/right,
center, surround left/right, surround back left/
right, front high left/right, subwoofer.)
1
Select the speaker on the screen for
which you want to adjust the distance
from the seating position, then press
.
2
Select a "Distance:."
3
Set the distance of the selected
speaker, then press
You can adjust the distance from 1.0 meter
to 10.0 meters (3 feet 3 inches to 32 feet
9 inches) in 1 cm (1 inch) steps.
To adjust the size of each
speaker
You can adjust each speaker's (front left/right,
center, surround left/right, surround back left/
right, front high left/right) size.
1
Select the speaker on the screen for
which you want to adjust the size, then
press .
2
Select a "Size:."
3
Set the size of the selected speaker,
then press .
• Large
If you connect large speakers that will
effectively reproduce bass frequencies,
select "Large." Normally, select "Large."
• Small
If the sound is distorted, or you feel a lack
of surround effects when using multi-
channel surround sound, select "Small" to
activate the bass redirection circuitry and
output the bass frequencies of each
channel from the subwoofer or other
"Large" speakers.
Tips
• The "Large" and "Small" settings for each speaker
.
• The surround back will be set to the same setting as
• When the front speakers are set to "Small," the
• If you do not use the subwoofer, the front speakers
Lets you set the bass crossover frequency of
speakers that has been set to "Small" in the
Speaker menu. Measured speaker crossover
frequency is set for each speaker after auto
calibration.
1
2
determine whether the internal sound processor
will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the subwoofer or other "Large"
speakers.
However, since bass sound has a certain amount of
directionality, it is best not to cut it, if possible.
Therefore, even when using small speakers, you
can set them to "Large" if you want to output the
bass frequencies from that speaker. On the other
hand, if you are using a large speaker, but prefer not
to have bass frequencies output from that speaker,
set it to "Small."
If the overall sound level is lower than you prefer,
set all speakers to "Large." If there is not enough
bass, you can use the equalizer to boost the bass
levels.
that of the surround speakers.
center, surround, surround back, and front high
speakers are also automatically set to "Small."
are automatically set to "Large."
Crossover Freq (Speaker

crossover frequency)

Select the speaker on the
screen you want to adjust, then
press .
Adjust the value, then press
.
continued
113 GB