Eq Settings; Multi Zone Settings - Sony STR-DA4600ES Operating Instructions Manual

EQ settings

You can use following parameters to adjust the
tonal quality (bass/treble level) of front, center
and surround/surround back speakers.
Bass
Level
(dB)
Frequency
(Hz)
Note
• This function does not work in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
– Dolby TrueHD, or Linear PCM signals with a
sampling frequency of 176.4 kHz and higher are
being received.
To adjust the equalizer on the
EQ screen
1
Select the speaker on the screen you
want to adjust, then press
2
Select "Bass" or "Treble."
3
Adjust the gain, then press

Multi Zone settings

You can make settings for the main zone, zone
2 or zone 3.
Multi Zone Setup
Treble
To turn the power on or off for
zone 2/zone 3
You can turn zone 2 or zone 3 operation on or
off. "Main" (this receiver) is always selected.
You cannot turn it off.
1
Select the zone you want to turn on or
off, then press
2
Select "ON" or "OFF," then press
x ON
x OFF
To select the output source for
each zone
You can select the source that is output to the
.
zone. Audio and video signals are output to
zone 2, while only audio signals are output to
zone 3.
.
1
Select the zone to which you want to
output audio/video signals, then press
2
Select "Input," then press
3
Select the input, then press
To adjust the volume for zone 2
You can adjust the volume in the main zone.
If "Sur Back Assign" is set to "ZONE2" in the
Speaker settings menu, you can also adjust the
volume of zone 2.
If you set "Zone2 Line Out Level" to
"VARIABLE," you can also adjust the volume
using "Multi Zone Setup."
.
.
continued
.
.
.
117 GB