Audio Settings - Sony STR-DA4600ES Operating Instructions Manual

Audio settings

You can make settings for the audio to suit
your preference.
Digital Legato Linear (D.L.L.)
The D.L.L. function is Sony proprietary
technology that allows low quality digital
audio signals and analog audio signals to be
played back with high quality sound.
x OFF
x AUTO 1
This function is available for lossy
compression audio formats and analog audio
signals.
x AUTO 2
This function is available for Linear PCM
signals, as well as lossy compression audio
formats and analog audio signals.
Note
• This function works when "A.F.D. Auto" is
selected. However, this function does not work in
the following cases.
– Linear PCM signals with a sampling frequency
of other than 44.1 kHz are being received.
– Dolby Digital Plus, Dolby Digital EX, Dolby
TrueHD, DTS 96/24, DTS-ES Matrix 6.1, DTS-
HD Master Audio, or DTS-HD High Resolution
Audio signals are being received.
A/V Sync (Synchronizes audio
and video output)
Lets you delay the output of audio to minimize
the time gap between audio output and visual
display.
x 0 ms – 300 ms
You can adjust the delay from 0 ms to 300 ms
in 10 ms steps.
Notes
• This function is useful when you use a large LCD
or plasma monitor or a projector.
• This function does not work in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
Dual Mono (Digital broadcast
language selection)
Lets you select the language you want when
you listen to the dual audio of a digital
broadcast. This feature only functions for
Dolby Digital sources.
x MAIN/SUB
Sound of the main language will be output
through the front left speaker, and sound of the
sub language will be output through the front
right speaker simultaneously.
x MAIN
Sound of the main language will be output.
x SUB
Sound of the sub language will be output.
Decode Priority (Digital audio
input decoding priority)
Lets you specify the input mode for the digital
signal input to the DIGITAL IN jacks or
HDMI IN jacks.
x PCM
When signals from the DIGITAL IN jack are
selected, PCM signals are given priority (to
prevent interruption when playback starts).
However, when other signals are input, there
may be no sound, depending on the format. In
this case, set this item to "AUTO."
When signals from the HDMI IN jack are
selected, only PCM signals are output from the
connected player. When signals in any other
format are received, set this item to "AUTO."
continued
119 GB