109818 Corner Post Assembly
READ THIS DOCUMENT BEFORE YOU ASSEMBLE THE CORNER POST.
Thank you for purchasing the universal corner post assembly. When properly assembled and
maintained, this product will provide years of reliable service. These instructions include helpful
hints and important information needed to safely assemble and properly maintain the corner post.
Please read these instructions before you begin. Corner post assembled in this example is for
use with an 10' fence. Adjust dimensions as needed for the height of your fence.
SAFETY PRECAUTIONS
•
An assistant is required during assembly.
•
Wear eye protection and gloves when handling the metal parts, driving the ground posts, and
drilling mounting holes.
•
Verify that no underground pipe, electrical cables, utility service, or communication cables are
present before you drive the ground posts into the ground.
•
Contact local building officials to determine applicable codes and other related restrictions
before you begin.
REQUIRED TOOLS
The following list identifies the main tools
needed for assembly.
•
Hammer and a block of hard wood
to drive ground post.
•
Tape measure, marker to mark hole
locations, and center punch.
•
Drill and 5/16" drill bit.
•
Rubber mallet to install plastic plug.
•
Small wrench set or an adjustable wrench
to tighten the 5/16" mounting bolts.
•
5/16" hex key wrench to
tighten the set screws
for the 90° corner swivel.
•
Level and string line
(recommended).
Revision date: 03.20.12
PARTS LISTS
The parts listed below are contained in
one (1) 109092 Corner Post Assembly kit:
•
(2)
FAH322 (5/16" x 3-1/2" Carriage Bolt)
•
(2)
FALB32B (5/16" Nut)
•
(2)
FAME51B (5/16" Flat Washer)
•
(1)
105968 (90° Corner Swivel
Combination for 1.90" pipe)
•
(1)
102676 (Ground Post)
•
(3)
190P120 (1.90" x 120" Plain Pipe)
(not shown)
F a r m T e k ®
Actual assembly may differ slightly from what is shown.
FAH322
FAME51B
*Photos not to scale.
FALB32B
105968