Maxitrol GV60 Advanced Troubleshooting page 39

QUESTIONS TO ASK
1. Is the room temperature and the time showing on the
remote display?
2. Does the motor turn the knob when the UP & DOWN
flame buttons on the handset are pushed?
3. Is the handset in the SUN TEMP, MOON TEMP, or
TIMER mode?
4. Has the handset been out of range for 6 hours?
5. Have you verified transmission of signal?
f i r e - p a r t s . c o m
Troubleshooting the GV60
POSSIBLE CAUSE
A blank display could indicate that the 9Volt battery in the
handset needs to be replaced.
Dead receiver batteries or the handset is not synced.
(See slide 25)
Unit may be OFF because the set temperature is lower than
the room temperature.
No communication for 6 hours will cause the fireplace to go to
STANDBY mode.
Handset – radio signal flashes when pressing UP & DOWN
flame button.
Receiver – beeps to confirm receipt of signal.
© 2013, Maxitrol Company 39