Maxitrol GV60 Advanced Troubleshooting page 28

f i r e - p a r t s . c o m
Receiver Reset Button
Small Flame Button on Handset
Receiver Components
Setting the Electronics Code
Synchronizing the Receiver and Handset.
Press and hold the receiver's reset button until you hear
one short beep and one long beep. After the second beep,
release the reset button.
Within the subsequent 20 seconds press the small flame
button on the handset until you hear two additional short
beeps coming from the receiver confirming the code is set.
If you hear one long beep, this indicates the code learning
sequence has failed or the wiring is incorrect. There are
65,000 random codes to select from.
NOTE: This is a one time setting only, and is not required
after mains power failure or changing the batteries of the
handset or receiver.
© 2013, Maxitrol Company 28