Testing Your Blood Pressure; Fitting The Cuff - Fora D40 DUO ultima Owner's Manual

Note:
• During memory deletion, do the following:
✓ To keep all saved results, press
✓ To delete all results, press
• If the device is idle for 3 minutes during the setting mode, it will turn off automatically.

Testing Your Blood Pressure

Fitting the Cuff

1. Connect the air plug of the tubing to the air jack of the device.
2. Assemble the cuff as shown in the illustration.
The smooth surface should be inside the cuff loop
and the metal D-ring should not touch your skin.
Note:
• Before using the cuff, be sure the cuff size fits with
your upper arm circumference.
3. Stretch your left (right) arm in front of you with your
palm facing up.
Slide and place the cuff onto your arm with the air
tube and artery mark region (in red) toward the
lower arm.
Wrap and tighten the cuff above your elbow. The
red line on the edge of the cuff should be approximately 0.8 to 1.2 inches (2 to 3 cm)
above your elbow. Align the tube over the main arteries on the inside.
4. Leave a little free space between the arm and the cuff. You should be able to fit 2
fingers between them.
5. Press the hook material firmly against the pile material. The top and bottom edges
of the cuff should be tightened evenly around your upper arm.
to keep the saved result.
twice to delete all memory.
Air Plug
EN-6
Pressure Cuff
Air Tube
RED LINESHOULD BE AT THE INSID
INDEX MUST