Parking Sensors; Setting The Desired Speed; Decreasing Speed; Recalling The Speed - Fiat 500 Hybrid 2020 Owner's Handbook Manual

SETTING THE DESIRED
SPEED
Proceed as follows:
activate the device by turning the ring
(C) fig. 89 downwards.
when the vehicle has reached
the desired speed, turn the ring (B)
upwards (or downwards) and release
it to activate the device. When the
accelerator is released, the vehicle will
automatically maintain the selected
speed.
If needed (e.g. when overtaking), you
can increase speed simply by pressing
the accelerator; when you release the
pedal, the car goes back to the speed
stored previously.
When travelling downhill with the device
active, the vehicle speed may slightly
exceed the set one.
WARNING Before turning the ring (B)
upwards or downwards, the vehicle
must travel at a constant speed on
level ground.
INCREASING SPEED
Once the electronic Cruise Control
has been activated, the speed can
be increased by turning the ring (B)
upwards.
98

DECREASING SPEED

To decrease the speed with the device
activated, turn the ring (B) downwards.

RECALLING THE SPEED

Before returning to the previously set
speed, you need reach a speed close
to it, and then press the button (A)
(CANC/RES) and release it.
DEACTIVATING THE
DEVICE
Lightly pressing the brake pedal or
pressing button (A) (CANC/RES)
deactivates the electronic Cruise
Control without deleting the stored
speed.
Changing gear deactivates the Cruise
Control.
DEACTIVATING THE
DEVICE
The electronic Cruise Control is
disabled by turning the ring (C) fig. 89
to the 0 position or putting the ignition
device at STOP
WARNING
129) While driving with the device active,
never move the gear lever to neutral.
130) In case of a malfunction or failure of
the device, contact a Fiat Dealership.
131) The electronic Cruise Control can
be dangerous if the system cannot keep
a constant speed. In specific conditions
speed may be excessive, resulting in the
risk of losing control of the vehicle and
causing accidents. Do not use the device
in heavy traffic or on winding, icy, snowy or
slippery roads.

PARKING SENSORS

(for versions/markets, where provided)
132)
34) 35)
SENSORS
Parking sensors are located in the rear
bumper fig. 90 and detect and inform
the driver, through an intermittent
acoustic signal, of the presence of
obstacles at the rear of the car.
90
ACOUSTIC WARNING
When reverse gear is engaged and
there is an obstacle behind the car an
acoustic warning is activated and the
F0S0578