Environmental Concerns - Zanussi ZRB935NW User Manual

m1 m2
m5 m6
m4
m3
• Open the doors. Un-
screw the middle hinge
(m2). Remove the plas-
tic spacer (m1).
• Remove the doors.
• Remove the spacer (m6)
and move to the other
side of the hinge pivot
(m5).
• Remove the left-hand
cover pin of the middle
hinge (m3,m4) and
move to the other side.
• Fit the pin of the middle
hinge (m5) into the left-
hand hole of the lower
door.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the side edge of
the appliance.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
36
• Unscrew the lover hinge
(b1)
• Remove the left-hand
cover pins (b4) and
move to the other side.
• Re-screw the lover
hinge (b1) on the oppo-
site side.
• Unscrew the lower hinge
pivot (b2) and the spacer
(b3) and place them on
the opposite side.
d2
d4
d3
d6
d5
• Disassemble the door
locking elements (d2,
d3) by unscrewing the
screw (d4).
• Remove stoppers in
both doors (d5, d6).
• Reverse the door lock-
ing elements (d2, d3),
move to the other side of
the other door and fix by
screwing in the screw
(d4).
• Re-insert the stoppers
(d5, d6) on the other
side of the doors.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please
contact your local council, your household waste disposal
service or the shop where you purchased the product.
• Unscrew the upper
hinge pivot and place it
on the opposite side.
• Fit the upper door on the
upper door pivot.
• Re-insert the upper door
on the middle hinge piv-
ot (m5) slightly tilting
both doors.
• Re-screw the middle
hinge (m2). Do not for-
get the plastic spacer
(m1).