This will service agent or qualified service personnel to avoid haz- prevent it from becoming a death trap for a child. ard. Power cord must not be lengthened. www.zanussi.com...
Page 3
• Ice lollies can cause frost burns if consumed straight from the appliance. Care and cleaning • Before maintenance, switch off the appliance and dis- connect the mains plug from the mains socket. www.zanussi.com...
Functions Menu +5°C in the fridge -18°C in the freezer By activating the key (D) the functions menu is operating. Each function could be confirmed by pressing button (E). www.zanussi.com...
Page 6
It is possible to de-activate the function at any time by slightly reduced. pressing key (D) until the corresponding icon will flash and then key (E). www.zanussi.com...
24 hours before placing the food to be frozen in the After 24 hours, when the freezing process is completed, freezer compartment. deactivate the Fast Freezing function (see "Fast Freezing Place the fresh food to be frozen in the bottom compart- function"). ment. www.zanussi.com...
Page 8
Once you are over the end points, push the baskets back in their position. The walls of the refrigera- tor are equipped with a series of runners so that the shelves can be posi- tioned as desired. www.zanussi.com...
• do not exceed the storage period indicated by the food tight containers or wrapped in aluminium foil or polythene manufacturer. bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stor- ed in the bottle rack on the door. www.zanussi.com...
Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem Possible cause Solution The appliance is noisy. The appliance is not supported prop- Check if the appliance stands stable (all erly. the four feet should be on the floor). www.zanussi.com...
Page 11
The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly. The appliance has no power. There is Connect a different electrical appliance no voltage in the mains socket. to the mains socket. Contact a qualified electrician. www.zanussi.com...
Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appliance: www.zanussi.com...
Page 13
Rear spacers You can find the two spacers in the bag with documenta- tion. Do these steps to install the spacers: Release the screw. Engage the spacer below the screw. Turn the spacer to the right position. www.zanussi.com...
Page 14
Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. www.zanussi.com...
Need help?
Do you have a question about the ZRB939NX2 and is the answer not in the manual?
Questions and answers