Technical Data; Installation - Zanussi ZRB935NW User Manual

Problem
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the bulb
Caution! Disconnect the plug from the mains
socket.
1. Pull outwards the hook of the lamp cover.
2. Remove the lamp cover.
3. Replace the lamp with one of the same power (the
maximum power is shown on the light bulb cover).
4. Install the lamp cover.
5. Connect the plug to the mains socket.
6. Open the door. Make sure that the light comes on.

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
34
Possible cause
The appliance has no power. There is
no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Height
Width
Depth
Connect a different electrical appliance
to the mains socket. Contact a qualified
electrician.
Close and open the door.
Refer to "Replacing the lamp".
1
2
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Force Center.
ZRB935NW ZRB935NX
1850 mm
595 mm
632 mm
16 h
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Solution
ZRB939NW ZRB939NX
2010 mm
595 mm
632 mm
16 h