Zanussi ZRB935NW User Manual page 35

Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
B
A
Rear spacers and levelling
2
1
3
Ambient temperature In the bag with the docu-
mentation, there are two
spacers which must be fit-
ted as shown in the figure.
Slacken the screws and in-
sert the spacer under the
screw head, then tighten
again the screws.
Removing the shelf holders
Your appliance is equipped with shelf retainers that make
it possible to secure the shelves during transportation.
To remove them proceed
as follows:
1. Move the shelf hold-
ers in the direction of
the arrow (A).
2. Raise the shelf from
the rear and push it
forward until it is freed
(B).
3. Remove the retainers
(C).
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
Warning! Before carrying out any operations,
remove the plug from the power socket.
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during the
operations.
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
35