Module Configuration - Advantech WISE-4610 Startup Manual

Notes
• Please install the CP210x USB to UART Controller driver.
• USB is not able to power up the module, and please ensure to remove the USB cable before RF transmitting.

Module Configuration

There are three ways to power up the WISE module, battery power, solar panel power and line power.
Open the rubber cover on the side of the WISE module and you can see a battery switch for turning on/off the battery power.
For the solar power, it is not only to recharge the battery but also to power up the device.
Please refer to the application wiring section for solar panel power and line power pin assignment.
Also, there is a USB port for the device configuration via WISE Studio but please note that the WISE device cannot be pow-
ered via USB.
6 WISE-4610 Startup Manual