JVC DT-V1710CG Instructions Manual page 16

How to Use SET-UP MENU
7Functions and Adjustment Range of Items
FUNCTION SETTING
• Checks the amount of time that the monitor has been
used.
• Sets the AUTO INPUT function ON/OFF. (When an
input card compatible with AUTO INPUT is installed.)
• Selects the audio channel group for the EMBEDDED
AUDIO. (When an input card compatible with
EMBEDDED AUDIO is installed.)
7 COLOR SYSTEM
Selects the color system when using the video input
card.
AUTO: Changes NTSC and PAL automatically.
NTSC: Keeps the color system NTSC.
PAL: Keeps the color system PAL.
NOTE:
• Normally select AUTO. However, if the input signal is
unstable, select NTSC or PAL.
7 AUTO INPUT
Detects the signal type and changes input
automatically to INPUT A (HD SDI input card) or
INPUT C (SDI input card) when HD SDI signal and
SD SDI signal are input through one signal cable.
• ON/OFF
Preparation for the AUTO INPUT function (See
illustration below)
1. Install HD SDI input card to SLOT1, and SDI input
card to SLOT2 (both cards need to be compatible with
AUTO INPUT), then connect the signal cable.
2. Input HD SDI signal or SD SDI signal to HD SDI input
card.
HD SDI input card
compatible with
AUTO INPUT
(Ex.: IF-C21HSDG)
E.AUDIO
HD SDI 1
IN
OUT
16
Selects the control systems
for the COLOR SYSTEM,
synchronized signal, RUSH
DELAY TIME, tally lamp
colors, and MAKE/
TRIGGER terminal.
SDI input card
compatible with
AUTO INPUT
(Ex.: IF-C21SD1G)
E.AUDIO SDI
INPUT 1
INPUT 2
SWITCHED
OUT
NOTES:
• Functions only when HD SDI input card or SD input
card compatible with AUTO INPUT is used.
• "INPUT SELECT ERROR" is displayed for approx. 3
seconds when different signal cables are connected to
both INPUT A and INPUT C and signals are input to the
each of them.
7 SYNC SELECT
Selects the synchronized signal.
INT.: The input video signal is synchronized with the
built-in sync signal.
EXT.: The input video signal is synchronized with an
external signal from an external sync terminal.
7 RUSH DELAY TIME
Sets the delay time between when the power button
is pressed and when the monitor actually turns on.
STD.: Power turns on about 1 second after the power
button is pressed.
SLOW: Power turns on about 3.2 seconds after the
power button is pressed.
NOTE:
• It is recommended to apply "SLOW" to some of the
monitors if you need to turn on multiple monitors at the
same time. You can control the rush current of the entire
system.
7 TALLY SELECT
Selects the color of the tally lamp on the upper front
panel.
GREEN: The tally lamp lights in green.
RED: The tally lamp lights in red.
NOTE:
• The tally lamp is controlled using the MAKE/TRIGGER
terminal of the REMOTE (external control) terminals.
☞ "How to Use the MAKE/TRIGGER Terminal" on page
21
(cont.)