Mirra 2 ® Arm Pad Replacement - HermanMiller Mirra 2 Manual

Y
Parts Included:
Arm Pad
Steps:
1. Using philips T20 torx bit
remove the front arm pad
bolt.
Z
© 2014 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra 2 are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
®
Mirra 2 Arm Pad Replacement
Tools Required:
T-20 Torx Driver
2. Lift up the arm pad and
slide it off.
Part no. 1BBSF3 rev D.
67