HermanMiller Mirra 2 Manual page 124

24. Using a 13mm deep socket
tighten the Arm Support Post.
Torque to 300 in/lbs.
26. Snap the two halves of the
Hip Pivot Bushing together.
Z
© 2016 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra 2 are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
25. Install the new Hip Pivot
Bushing on the ball end of the
Arm Support Post. Note: The
bushing will only go on one
way.
27. Rotate the seat to the in
use position sliding the Pivot
Bushing into the keyed opening
in the seat.
Part no. 1BBT3J rev D
124