Energetics POWER RUN 7.9 HRC Manual page 5

Assembly
1. Remove the treadmill from the shipping box and remote the console until it is in an appropriate
position and screw in one 806 bolt in both side handlebar.
2. Lift the uprights to the unfolded position and screw using 2 ×810 bolts, then tighten 809 bolts into the
base of upright, finally cover with 2 ×213 caps.
3.
Remove bolt 806 from the left hand side then Insert the handlebar 208 to fix use 1
808; repeat the same process for the right handle bar.
4. Secure both side handlebar using another 2 × 806 bolts and 2 ×808 washers.
5. Clip the handlebar cover Upper 202 first and then clip the handlebar cover LL 204 and handlebar
cover LR 205 over the handlebars: and secure using 2×844 screws. Then repeat for the other
handlebar.
6. Attach the water bottle holder to the console housing-upper and push down until snap in place.
Handling
A. After assembly, the base frame can be adjusted to accommodate slightly uneven ground. Turn the
adjustment knobs on the bottom of the base frame to level the treadmill to the floor.
B. To fold the treadmill for storage first be sure that the deck is at the lowest incline level. Simply lift the
deck up from the rear of the treadmill and fold up as shown in figure B1 until it locks in place. TO
PREVENT INJURY BE SURE YOU HAVE A FIRM HOLD WHEN RAISING THE DECK. You will
hear a "click" sound as the lock engages as shown in figure B2.
B1
C. To unfold the treadmill for use stand behind the treadmill and support the deck with your hands.
Next release the lock with your foot by stepping on the release lever as shown in figure C1. TO
PREVENT INJURY BE SURE YOU HAVE A FIRM HOLD ON THE DECK BEFORE RELEASING
THE LOCK. Slowly lower the deck as shown in figure C2 until it rests securely on the ground.
C1
2
1
5
B2
C2
× 806 and 1×