Infant Car Seat - BABYTREND Muv Tango Pro Travel Instruction Manual

INFANT CAR SEAT

THE INFANT CAR SEAT
WARNING:
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
10)
Attaching to the child tray: From
•
the rear side of the stroller engage
both car seat support tabs
(Fig. 10a).
• To attach an infant car seat to the
stroller rotate the tray to a vertical
position. Press the buttons on each
side of tray to rotate down 90°
(Fig. 10b).
• Place the infant seat onto child tray
in a rear facing position. Position the
infant seat over the tray and gently
apply pressure to snap into place
(Fig. 10c).
• NOTE: It is very important that the
short clip is always fastened around
the infant car seat.
When the infant car seat is seated
firmly into place, locate the short clip
on the left side of the stroller. Place
the short clip through the lap belt
opening on the infant seat. Adjust
strap tension by pulling loose end of
strap (Fig. 10d).
15
15
Copyright © 2021, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Avoid
Fig. 10a
Fig. 10b
"Click"
Fig. 10c
Removing the car seat from the child tray:
• Rotate the car seat handle into the
carry position. Loosen the short clip
tension and remove short clip from
car seat (Fig. 10d).
• To remove the Infant Car Seat, squeeze the release handle located at
the Top-rear of the seat and carefully lift upward on the seat
(Fig. 10e).
• From the rear side of the stroller disengage both car seat support
tabs (Fig. 10f).
Fig. 10e
Copyright © 2021 Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
Pull
Fig. 10d
Fig. 10f
16
16