Table of Contents
Advertisement
2. Press the 1 key to enter the Triggering Settings Menu.
3. Enter a 0 to disable the triggering or 1 to enable the triggering.
4. Enabling the triggering allows you to select which transducer and value will trigger the data
recording during a test.
Enter RUN Display Options:
1. Press the 2 key to enter the System Setup Menu. Press the 2 key to enter the Test Options
Menu.
2. Press the 2 key to enter the Display Options Menu.
This menu allows the user decide how many channels are displayed in the RUN menu. On a 4
channel KEI-095 3 or 4 channels are selectable. An 8 channel allows the user to select 3,4 or 8
channels.
This menu also allows the user to decide if the first channel displays angle or travel. Default is
set for travel.
Enter HUD (Heads up Display) Setup:
1. Turn on the brake tester. Press any key to display the main menu.
2. Press the 2 key to enter the System Setup menu. Press the 2 key to enter Test Options
Menu.
3. Press the 4 key in the setup menu to set HUD (Factory)Default bargraph values for Upper
Limit, Target, Lower Limit.
4. Press the 3 key to enter the HUD Option menu.
The display will show the following.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
*** HUD OPTIONS ***
Head Up Disp. = OFF
0 = OFF
Press * to Abort
ENGINEERING, INC.
1 = ON
Page 8 of 16
Revised: 11-NOV-99
Advertisement
Table of Contents
