Related Manuals for KEMKRAFT KEI-095
Summary of Contents for KEMKRAFT KEI-095
- Page 1 INSTRUCTIONAL MANUAL BRAKE PEDAL TRAVEL TESTER MODEL KEI-095/095A 96-002.doc Page 1 of 9 Revised: 21-AUG-96 47650 CLIPPER DR. PLYMOUTH TWP., MI. 48170 (734) 414-6500...
-
Page 2: General Description
MODEL KEI095/095A BRAKE PEDAL TESTER GENERAL DESCRIPTION The KEMKRAFT Model KEI-095 Brake tester is a precision test instrument which will display and record brake pedal travel, brake pedal effort, and car deceleration during vehicle drive testing. Setup is accomplished in a few minutes with three transducers and a cigarette lighter plug. -
Page 3: Operation
OPERATION The operation of the KEI-095 Brake Tester is controlled by various menus. Select the required operation from the menu using numbers on the keypad. Any entered data is entered on the keypad. Decimal points are added automatically. - Page 4 KEMKRAFT ENGINEERING, INC. MODEL KEI095/095A BRAKE PEDAL TESTER Press 0 to ZERO all Press 1 for DATA Co Press 3 to Rst Peak Press * to Abort The test screen will now be displayed. Pedal Now Peak Travel Force Decel The current data value is displayed under the Now column and the greatest positive or negative peak value is displayed under the Peak column.
-
Page 5: System Setup
KEMKRAFT ENGINEERING, INC. MODEL KEI095/095A BRAKE PEDAL TESTER SYSTEM SETUP Certain system parameters must be modified when changing to a new vehicle or adjustment is required. The pedal length from pivot point to the middle of the brake pedal must be changed when switching to a new vehicle. -
Page 6: Transducer Calibration
MODEL KEI095/095A BRAKE PEDAL TESTER TRANSDUCER CALIBRATION The KEI-095 brake tester works by comparing the angle on the brake pedal level transducer to the angle of the floor transducer. The angles must be the same from each transducer. Because the pedal travel and deceleration values are derived from these angles, the angles must be accurate for the system to be accurate. - Page 7 KEMKRAFT ENGINEERING, INC. MODEL KEI095/095A BRAKE PEDAL TESTER When the fifth number is entered, the display will show the next recommended angle to be entered. The display will instruct the operator to set the angle transducers to the next negative angle.
-
Page 8: Downloading Data
Angles display. To calibrate the Pedal Force Transducer: Connect the KEI-095 brake tester to a 12.6 to 15 volt, 500 ma power supply. Connect all transducers to their brake tester ports. Turn on the brake tester. Press any key to display the main menu. - Page 9 If the data is to be saved on disk, press the F2 key to save. Data is not permanently stored on disk until F2 is pressed. The data remains in the KEI-095 Brake tester memory and can be download as many times as desired. To clear the memory and reset the pointer to DATA-000, select the Download menu and press the 9 key to reset memory.