Table of Contents
Advertisement
7. To begin data storage at any time press the 1 key.
This data storage screen will now be displayed.
The first line of the test screen R:000, indicates that the brake tester is now collecting data. The
number will begin counting upward to indicate how much memory has been used.
The second line of the test screen T:000, tells you the total memory that has been used. The
memory is full when the display reaches T:285.
The third line of the test screen S:00, indicates the number of samples per second.
The fourth line of the test screen will change to RUN, indicating that the Brake Pedal tester is
in data acquisition mode.
To stop data collection at any time, press the 1 key again.
The start and stop time of each test (pressing the 1 key) is recorded and stored in memory to
identify tests.
8. Press the * key at any time to abort the data collection and return to the test menu. If data
collection is in progress, when the * key is pressed, the data collection will be stopped and
the data end time stamped with the current time.
Certain system parameters must be modified when changing to a new vehicle or adjustment is
required. The pedal length from pivot point to the middle of the brake pedal must be changed
when switching to a new vehicle.
The clock should be checked for accuracy and reset for daylight savings time.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
R:000
T:000
S:.10
RUN:
SYSTEM SETUP
ENGINEERING, INC.
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
Page 6 of 16
Revised: 11-NOV-99
Advertisement
Table of Contents
