Table of Contents
Advertisement
To run a test:
1. Be sure all setup is complete as detailed in the Installation section. Be sure the car is
running. Turn on the Brake Tester power switch. Always start and stop the engine with
Brake Tester power off.
2. Press the 0 key to select START TEST. The Test menu will be displayed. Press the 0 key
again to start the test.
3. A menu screen will display that shows the functions of each key during testing. Press any
key to start the test.
4. The test screen will now be displayed.
The current value is displayed in the first data column and the greatest positive or negative
peak value is displayed in the second data column.
The Units are:
5. With the engine on, the shifter in park, and your foot off the brake pedal, press the 0 key to
Zero all values. The Brake tester will store the zero values until the unit is switched off.
6. While testing, the Peak value can be reset by pressing the 3 key at any time. This has no
effect on data storage or any other reading, it resets the displayed peak only.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
0 = Zero All XDCRs
1 = Data Col STR/STP
3 = Reset Peak
Press (*) to Abort
TRAV:
FRCE:
DCEL:
PRES:
Travel = Centimeters
Force = Newtons
Decel = 100%= 1g
Pressure = Bars
ENGINEERING, INC.
0.0
0.0
0.0
0.0
0.0
0.0
0.0
0.0
Page 5 of 16
Revised: 11-NOV-99
Advertisement
Table of Contents
