Table of Contents
Advertisement
4. If the Pedal force transducer is used, place it on the brake pedal and secure it firmly in
place.
5. If the Brake Pressure transducer is used, install it on the master cylinder using an adapter
(user supplied). The threads are 1/4-18 NPT Male. If the Brake Pressure Transducer is not
being used, a terminating plug (KE095P1) for the Pressure connector is supplied.
6. Route all transducer cables so that they do not interfere with pedal operation. The cables
must have enough slack to move freely without binding.
7. Plug the transducer cables and the power cable into the Brake tester. The brake tester
connectors are marked and keyed so no damage can occur from incorrect cable connection.
8. Start the car and plug the power cable into the car cigarette lighter.
9. Turn the Brake Tester on. The start-up screen will be displayed. Press any key to enter the
Main menu.
10. Press the 2 key to enter the system setup menu and press the 4 key again to display the
pedal angles.
11. Adjust the pedal and floor transducers so that their angles read less than +/- 2 degrees.
Adjust the transducer angles by loosening the center thumbscrew slightly, adjusting the
transducer, and carefully re-tightening the screw.
The installation is now complete. Press the * key twice to return to the main menu and the
tester is ready to be used.
The operation of the KEI-095 Brake Tester is controlled by various menus. Select the required
operation from the menu using numbers on the keypad. Any entered data is entered on the
keypad. Decimal points are added automatically.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
0 = Start Test
1 = Calibrate
2 = System Setup
3 = Download Data
ENGINEERING, INC.
MAIN MENU
OPERATION
Page 4 of 16
Revised: 11-NOV-99
Advertisement
Table of Contents
