To Calibrate The Aux. Pressure Transducers - KEMKRAFT KEI-095A Instructional Manual

5. To prevent unwanted access to the calibration modes a numeric code must be entered.
Enter "1", "2", "3", "4" on the keypad. The calibration menu will be displayed.
6. Press the 3 key to calibrate the brake pressure transducer.
7. The display will show the current raw transducer output. For the brake pressure transducer
set the calibration box switch to ZERO. Press the 0 key.
8. Set calibration box switch to CAL. Enter the 5-digit calibration number that is on the label
on the front panel. Each pressure XDCR has it's own CAL# depending on the serial
number of the transducer.
9. When the fifth number is entered, the calibration is complete. Press the * key to exit the
calibration mode.

To calibrate the AUX. Pressure Transducers:

1. Connect the KEI-095 brake tester to a 12.6 to 15 volt, 500 ma power supply. Connect all
transducers to their brake tester ports.
2. Connect the pressure transducer to AUX. CH1-4.
3. Turn on the brake tester. Press any key to display the main menu.
4. Press the 1 key to enter the Calibration mode.
5. To prevent unwanted access to the calibration modes a numeric code must be entered.
Enter "1", "2", "3", "4" on the keypad. The calibration menu will be displayed.
6. Press the 4 key to calibrate the AUX. pressure transducers.
7. Press 1 to select the channel 1 to calibrate.
8. The display will show the current raw transducer output. With the Aux. pressure transducer
set to ZERO. Press the 0 key.
9. Apply calibrated pressure to the Aux. transducer under test. Enter the calibrated pressure
value in Bars.
10. When the fifth number is entered, the calibration is complete. Press the * key to exit the
calibration mode.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
ENGINEERING, INC.
Page 14 of 16 Revised: 11-NOV-99