Enter A New Time And Date; Display Pedal And Floor Transducer Angles; Transducer Calibration - KEMKRAFT KEI-095A Instructional Manual

12. Press the 3 key to turn off the LCD display update, Press the 4 key to turn on the LCD
display update. (The Bargraph will continue to operate until disabled.)
13. Press the * key to return to the System Setup and main menus.

Enter a new time and date:

1. Turn on the brake tester. Press any key to display the main menu.
2. Press the 2 key to enter the System Setup menu. Press the 3 key to set the time and date.
3. The display will show the current time and date.
4. Press the 1 key to change the time if required.
5. Enter the new time, in 24 hr format (1:00 pm = 13:00:00), on the keypad. Enter a 2 number
hours, 2 number minutes, and 2 number seconds. The display will return to display the new
time.
6. Press the 0 key to change the date if required.
7. Enter the new date on the keypad. Enter a 2 number months, 2 number days, and the last 2
digits of the year. The display will return to display the new date.
8. Press the * key to return to the System Setup and main menus.

Display Pedal and Floor transducer angles:

1. Press the 2 key to enter the System Setup Menu.
2. Press the 4 key to display the transducer angles.
3. Press * to Exit.
The KEI-095 brake tester works by comparing the angle on the brake pedal level transducer to
the angle of the floor transducer. The angles must be the same from each transducer. Because
the pedal travel and deceleration values are derived from these angles, the angles must be
accurate for the system to be accurate. Periodic re-calibration of the system is necessary.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)

TRANSDUCER CALIBRATION

ENGINEERING, INC.
Page 10 of 16 Revised: 11-NOV-99