Table of Contents
Advertisement
The KEMKRAFT Model KEI-095 Brake tester is a precision test instrument which will display
and record brake pedal travel, brake pedal effort, brake line pressure, and car deceleration
during vehicle drive testing. Setup is accomplished in a few minutes with four transducers and
a cigarette lighter plug. Data is stored in the Brake Tester for approximately 4.5 minutes of test
time at the rate of 10 data readings per second. Multiple tests can be run and each test is
identified by its start and stop time/date.
1. Open the KEI-095 Brake tester box and remove the two pedal transducers and power cable.
2. Place the Floor transducer on a stable area of the car with the front line marking facing
toward the front of the car. Align the transducer so that the axis of the transducer is exactly
parallel to the centerline of the car. See figure 1. Rotate the transducer so that the number
label faces up.
3. Place the Pedal transducer on the pedal arm. Lock the fixture securely in place. Adjust the
multi-axis fixture so that the transducer is level and parallel to the centerline of the car.
Rotate the transducer so that the number label faces up, with the wires toward the front of
the car.
96-005.doc
47650 CLIPPER DR. PLYMOUTH TWP., MICHIGAN 48170 (734) 414-6500
KEMKRAFT
MODEL KEI-095A BRAKE PEDAL TESTER (METRIC)
GENERAL DESCRIPTION
INSTALLATION
FRONT
PEDAL
XDCR
NUMBER LABEL
ENGINEERING, INC.
FRONT
FLOOR
XDCR
Figure 1
Page 3 of 16
CAR DIRECTION
OF TRAVEL
Revised: 11-NOV-99
Advertisement
Table of Contents
