Maintenance; Cleaning; Fuse Replacement - Acom Owner's Manual

User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch

7. MAINTENANCE

The user IS NOT expected to perform any repairs, except replacing fuses (see Section
and repairing antennas or coaxial cables on the feeders.
If needed, call your dealer's service provider or the manufacturer directly (see Section

7.1. Cleaning

Do not use any solvents for cleaning. They may be dangerous to you and damage tuner
surfaces.
Do not disassemble the tuner. Cleaning of the tuner outer surface can be done with a piece of soft cotton
cloth lightly moistened with clean water.

7.2. Fuse Replacement

For replacement, only use standard fuses from the types recommended below.
There are two fuses in the tuner. They are located under a small cover on the front panel (see
, Pos. 6). The fuses are European size 5x20 mm, ceramic (or glass) body cartridge.
04AT tuner
Fuse F1 specification:
"F" type (fast-acting / quick-acting / fast blow / quick blow);
•
Rated for 2 A and 250 V.
•
Suitable fuses are:
EATON Bussmann, PN: GMA-2-R (glass body cartridge);
•
This fuse can be ordered from:
Littelfuse, PN: 0235002 (glass body cartridge);
•
This fuse can be ordered from:
May 2021
- Farnell (www.farnell.com), PN: 1150627;
- Mouser (www.mouser.com), PN: 504-GMA-2-R.
- DigiKey (www.digikey.com), PN: F4724-ND or F2680-ND;
- Farnell (www.farnell.com), PN: 1608243;
- Mouser (www.mouser.com), PN: 576-0235002.
CAUTION
NOTICE
S e c t i o n MAINTENANCE | Page 53 of 72
)
7.2 Fuse Replacement
).
1.2 Owner Assistance
Figure 2-1 ACOM