Figure 2-8 Securing The Tuner To A Mast - Acom Owner's Manual

User's Manual | ACOM 04AT | Remote Automatic Antenna Tuner and Switch
Finally, slip the Weather Protection Cover ACOM 04-WP over the tuner (see
Figure 2-6 Tuner installed on a
(Pos. 1) - directing it with the protruding part (marked with ACOM) up. Place it over the provided four carrying
pins protruding from the tuner chassis. Carefully align the protection hood until the pins fit into the respective
holes. The cover will go down a bit and will rest on the five carrying plates in the tuner base.
Check whether all walls of the protection hood are equidistant from the tuner chassis and whether their
bottom edges are parallel.
Use the provided fixing elements in the installation kit to fix the protection hood securely in place. Loosely
screw all nuts and screws at first, then fasten them tightly.
1
3
When mounting in the open, never install the tuner in a slanted position neither with
protection hood down, to avoid contaminating the inside of the assembly, and to prevent
precipitation from seeping into it. This may cause damage that is not covered by the
warranty!
May 2021
wall, Figure 2-7 Mast installation bracket

Figure 2-8 Securing the tuner to a mast

Figure 2-8 Securing the tuner to a mast
NOTICE
Figure 2-5 Wall installation bracket
, and
Figure 2-8 Securing the tuner to a mast
2
S e c t i o n INSTALLATION | Page 27 of 72
,
),