How To Assemble Your Ceiling Fan Blades; How To Assemble Your Switch Cup Assembly - Fanimation EDGEWOOD FP9060 Series Instructions Manual

How to Assemble Your Ceiling Fan Blades

CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
With a phillips screwdriver, tighten 3/16"-24 serrated
head screws with flat washers to secure the blade to
the blade holder. (Figure 1)
2. Attach assembled blade holders to the motor
hub using the provided screws with lock washers in
HARDWARE bag. Make sure the screws securing
the blade holders to the motor hub are tight and that
the blade holders are properly seated. (Figure 2)
NOTE: Periodically check blade holder hardware
and resecure if necessary.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.

How to Assemble Your Switch Cup Assembly

1. Remove the three screws from the switch cup
assembly and retain screws for later. (Figure 1)
3/16"-24
Serrated Head Screw and
Flat Washer (4 each per blade)
Blade Holder
3/16"-24
Serrated
Head Screw
Flat Washer
Blade Holder
1/4"-20 S crew
(2 Per Assembly)
14
Blade
Figure 1
HARDWARE USED:
X 20
X 20
Figure 2
HARDWARE USED:
1/4"-20
X 10
Screw
Figure 1
Switch Cup
Assembly