How To Install Your Canopy Housing (Downrod) - Fanimation EDGEWOOD FP9060 Series Instructions Manual

How to Wire Your Ceiling Fan (Continued)
3. After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads to one side of the box
and the black leads toward the other side. (Figure 3)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.

How to Install Your Canopy Housing (Downrod)

1. Slide the ceiling canopy over the mounting bracket
with the two loosened screws going into the "L" slots in
the canopy. Be sure all wiring is tucked into the ceiling
canopy and is not pinched. Once the canopy is flush
with your ceiling, turn clockwise to seat the screws into
the keyed portion of the slot. Tighten the screws and
install the remaining two screws removed in step 1 of
page 10 (How to Hang Your Ceiling Fan) to secure
the ceiling canopy to the hanger bracket. (Figure 1)
2. Assemble the canopy screw cover, by twisting in a
clockwise direction and up to the ceiling canopy.
(Figure 2)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and
the ceiling.
3. Push the canopy trim ring up to conceal the screws,
such that the mounting tabs seat into the dimpled
grooves in the ceiling canopy midway between the
screws. (Figure 3)
Wire Connectors
Green Wire
(Ground) from
Supply
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground) from
Hanger Ball
12
HARDWARE USED:
X
White Wire
from Supply
Listed
Outlet Box
Household
White Wire
Supply
from Fan
Black Wire
from Supply
Blue Wire
from Fan
Black Wire
from Fan
Figure 3
Figure 1
Ceiling Canopy
Canopy Screw
Cover
Figure 2
Canopy Trim Ring
Figure 3
3