Parameter Assignment And Structure Of The Module/Channel Parameters - Siemens SIMATIC ET 200SP HA Equipment Manual

Drivers, parameters, diagnostics messages and address space
A.2 Parameter assignment and structure of the module/channel parameters
Error_ Error_ Cause
Code_ Code_
1 2
0xE1 0x01 Reserved bit set
0xE1 0x02 Invalid diagnostics enable bit set for operating mode
0xE1 0x05 Invalid encoding for encoder type
0xE1 0x0B Invalid coding for pulse stretching
0xE1 0x0E Invalid redundancy parameter assignment
0xE1 0x21 Channel must be disabled due to change-over con‐
tact mode
0xE1 0x22 Encoder type "Change-over contact" is selected.
Select the value "Normal" for the "Digital input" pa‐
rameter.
0xE1 0x23 invalid coding of flutter monitoring
Valid parameters
Only the values specified in the following are permitted. Values that are not listed are rejected
by the module.
Every parameter data record is checked by the module. If an incorrect parameter is detected, the
entire data record is rejected and the parameters of the module remain unchanged.
A.2 Parameter assignment and structure of the module/channel
parameters
Structure of data record 128
Data record 128 has a length of 108 bytes.
It contains module parameters as well as channel or technology parameters of the 16 channels;
6 bytes each.
The channel or technology parameters are divided into parameters that affect the actual signal
acquisition or settings and diagnostics enables.
42
Remedy
Check and correct the parameters
Equipment Manual, 08/2019, A5E39293880-AD
DI 16xNAMUR HA