Parameters; Parameter Types; Module/Channel Parameters - Siemens SIMATIC ET 200SP HA Equipment Manual

Parameters

6.1

Parameter types

Definition
You can define the mode of operation of the I/O module via the parameter types, thereby
influencing the functions supported by the module.
The time stamp is configured in the configuration dialog of the I/O module.
Description
There are two types of parameters:
• Module/channel parameters (data record 128)
• System parameters (potential group, IO redundancy)
6.2

Module/channel parameters

Definition
Module/channel parameters are specific parameters whose configuration can affect the entire
module or channels.
Description
The following module/channel parameters are available:
Parameters
Diagnostics, Missing sup‐
ply voltage L+ (Page 21)
IO redundancy
(Page 21)
Diagnostics: short-cir‐
cuit (Page 21)
Diagnostics: wire break
(Page 22)
Diagnostics: change-
over contact error
(Page 22)
DI 16xNAMUR HA
Equipment Manual, 08/2019, A5E39293880-AD
Value range
• Enabled
• Disabled
• None
• 2 modules
• Enabled
• Disabled
• Enabled
• Disabled
• Enabled
• Disabled
Default Changing parame‐
ter settings in RUN
Enabled Yes
None Yes
Enabled Yes
Enabled Yes
Disabled Yes
6
Efficiency range
Module
Module
Channel
Channel
Channel
19