Model 8800-2-4B Add-On Module; Introduction; Installation Overview; Ip Address Configuration - Geokon GeoNet 8800 Series Instruction Manual

5.

MODEL 8800-2-4B ADD-ON MODULE

5.1 INTRODUCTION

Model 8800-2-4B (Ethernet compatibility) is an add-on module for the gateway
to allow the end user to easily add remote communications and data download
functionality.
Each module comprises a weather proof enclosure 305 x 254 x 152 mm (12" x
10" × 6") in size, a 7 amp hour rechargeable battery, a charger, and the
necessary cables to interface with a GeoNet gateway.
When an add-on module is paired with a gateway, the gateway is powered by
the rechargeable battery inside the module. The charge level of the battery can
be monitored using the Agent software.

5.2 INSTALLATION OVERVIEW

Modules are shipped with the batteries uninstalled and the fuse distribution
board switch in the OFF position. To deploy modules, install the batteries and set
the switch to the ON position. Use the provided black 10-pin to 10-pin
connecting cable to connect the module to the gateway.
Install D cell batteries in the gateway and set the battery switch to the
appropriate setting to ensure communication between the gateway and the
loggers will not be interrupted if the battery level drops. See Section 3.2.1.

5.3 IP ADDRESS CONFIGURATION

sets the module to communicate with a GeoNet gateway; however, the
GEOKON
user must finish the setup so that it works with their network. Configure an IP
address by following the instructions below.
Note: The following steps should only be performed by your network
administrator. NPort Administrator (on CD) should be installed and used to
configure the required IP changes.
1. Connect a computer to the module via the Ethernet Port.
2. Open NPort Administrator and click Search. (By default, the MOXA 5110A
IP Address 192.168.127.254 will be displayed.)
3. Double-click on the IP Address under the configuration window.
4. In the configuration window, click on the Network tab.
5. Check the boxes next to Modify IP address and Modify Netmask.

FIGURE 34: Nport Configuration

MODEL 8800 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | MODEL 8800-2-4B ADD-ON MODULE | 27
34: