Checking The Brake Linings Of The Rear Brake - Husqvarna EE 5 2022 Owner's Manual

14 BRAKE SYSTEM
14.14
72
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the appli-
cable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
M01730-10
H01654-10

Checking the brake linings of the rear brake

Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized Husqvarna Motorcy-
cles workshop will be glad to help.)
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Check the brake linings of the rear brake. (
Main work
–
1
Remove screws .
–
2
Take off cover with washer
–
Add brake fluid up to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover with washer and membrane.
–
Mount and tighten the screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled using water.
Finishing work
–
Remove the motorcycle from the lift stand. (
p. 45)
p. 72)
3 4
and membrane .
A
.
10 mm (0.39 in)
p. 98)
p. 45)