Utilization Rules - Timberk Harmony Series Instruction Manual

No atomizing
There is white patches from the
water on objects around the
humidifier (salts, separating out
from water)
Steam has a bad smell
During the operation of the
device, condensate is forming on
the upper part of the humidifier
and on surrounding objects
During the operation of the device
water appears next to it
Water appears next to the
humidifier, when it is off

11. UTILIZATION RULES

After the lifetime of the device expires, it should be recycled in compliance with the laws, rules
and methods in region of recycling. Detailed information about the recycling of the device, you
can receive from a representative of the local authorities, after providing full information about the
device. The manufacturer and authorized organization of the manufacturer do not carry
responsibility for the fulfillment by the Buyer of the requirements of legislation on utilization and
methods of utilization of the device selected by the Buyer. The lifetime of the device is indicated in the
warranty card. Warranty period for the device and warranty terms are specified in the warranty card. The
warranty card is an integral part of the documentation supplied with this unit. If there is no warranty card in
the delivery set, ask for it from the Seller. The warranty card provided by the Seller must conform to the
manufacturer's form.
The manufacturer and the authorized organization of the manufacturer remove responsibility for any possible
harm which can be caused to people, animals or property directly or indirectly, if this harm occurred as a
result of noncompliance with the rules and operating conditions, installation of the device, intentional or
reckless actions of the user- and / or third parties, as well as in situations caused by natural and / or
anthropogenic accidents.
The power cord is poorly
connected to the outlet
White patches have
formed on the membrane
There is a lot of salts in the water
(calcium and magnesium)
Stale water is used
Remains of stale water or waste
have accumulated in the unit's
case or the atomizer
High humidification intensity is
set.
Room humidity and
room temperature are high
High humidification intensity is
set.
The water tank is badly installed
on the unit's base and there is a
gap between them.
White patches have formed on
the membrane and in grooves for
water (in the unit's base).
Water tank is leaking
18
Connect the power cord into
the outlet carefully
Clean the humidifier's membrane
with a special brush
Use filtered water
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered water
Decrease the humidification
intensity
Decrease the humidification
intensity
Turn off the unit and make sure
the water tank is installed
correctly on the base, without any
gaps between the tank and the
base.
Clean the unit according to the
cleaning and servicing
instructions.
Contact an
authorized service center
IM2020