Programming Functions; Service Parameters - Thermo Scientific TSX Series Installation And Operation Manual

9.3 Programming
Functions

9.4 Service Parameters

Thermo Scientific
You can enter the programming mode by pressing the Scan button (
holding for approximately 5 seconds. The display will then flash "Prg" to indicate
that you have entered the programming mode. Use (
modify the values and press the Scan (
next screen.
Note If the alarms are enabled, all parameters are read only and cannot be edited.
Table 9. Setpoint Programming Functions
Screen/Button
1 Initial Screen
)
2 Press Scan (
)
3 Press Scan (
)
4 Press Scan (
If the unit is left idle for a period of approximately 30 seconds during program
mode, the program mode shall be exited.
If at any point the scan button is pressed and held for a period of approximately
10 seconds, the unit shall enter the service mode.
You can enter the service mode by pressing the Scan button (
for approximately 10 seconds while in Programming mode (refer to Section 9.3).
The display will then flash "SEr" to indicate that you have entered the service
mode followed by the software checksum values flashing on the screen. The
service icon ( ) will also illuminate. Use up (
modify the values and press the scan (
next screen.
Note If the alarms are enabled, the unit will not enter Service Mode.
) button to save the value and go to the
Function Summary
The temperature that the unit is
Unit Setpoint
set to run
The temperature that will
Cold Alarm
actuate the cold alarm (if
Temperature
active)
The temperature that will
Warm Alarm
actuate the warm alarm (if
Temperature
active)
Exit Program Returns to normal operating
Mode screen
) and down (
) button to save the value and go to the
TSX Laboratory Refrigerators
) and
) and ( ) buttons to
) and holding
) buttons to
33