Pre-Installation Check - RIB BOSS 24V SLAVE DX Manual

The door lever's length
cannot exceed the 83 cm
1 - 1 BOSS MASTER operator + 1
BOSS SLAVE operator
2 - Aerial
3 - Blinker
4 - BLOCK WIRELESS key
selector
5 - Photoelectric cells (internal)

PRE-INSTALLATION CHECK

For doors with a total width up to 6 m, maximum height 2,5 m or a total surface area of 12 square metres and door lever's
length with maximum length 83 cm, 2 BOSS (MASTER AA40840 + SLAVE AA40845) device should be used; mounted as
shown in Fig. 3, with a PAIR OF STRAIGHT LEVERS code ACG8720 (or a PAIR OF CURVED LEVERS code ACG8722), the
accessories for LATERAL TRANSMISSION for 2 operators cod. ACG8715 and 2 SHORT MOUNTING PLATE codes ACG8189 or
2 LONG MOUNTING PLATE codes ACG8188.
- Check that the available space between the moving frame of the door and external frame with counterweights exceeds 15
mm. If so, the STRAIGHT LEVERS can be mounted. Otherwise, mount the CURVED LEVERS if the distance is less than 15
mm, making sure to remain within the assembly parameters described in Fig. 4.
- Check that the up-and-over door slip bearings are not blocked or obstructed and that the counterweight fastening cables
are in correct working order.
- Remove, if present, the manual closing lever connected to the locking device.
N.B. It is obligatory to uniform the characteristics of the door to the standards and laws in
force. The door can be automatized only if in a good state and if in accordance with EN
12604 standard.
No trapping points must be generated (for example between horizontally pivoted open door
and wall).
4
5
COMMAND TYPE
with manned operation
with visible impulses
(e.g. sensor)
with
impulses (e.g. remote
control device)
automatic
* a typical example are those shutters which do not have access to any public way.
A: Command button with manned operation (that is, operating as long as activated), like
code ACG2013.
B: Key selector with manned operation, like code ACG6098.
C: Adjustable power of the motor.
D: Safety edges, like code ACG8610 or Photoelectric cells code ACG8026 and/or other
safety devices to keep thrust force within the limits of EN12453 regulation - Appendix A.
E: Photocells, like code ACG8026 (To apply every 60÷70 cm for all the height of the
column of the gate up to a maximum of 2,5 m - EN 12445 point 7.3.2.1).
33
1
Parts to install meeting the EN 12453 standard
USE OF THE SHUTTER
Skilled persons
(out of public
area*)
A
C or E
not visible
C or E
C and D, or E
2
3
5
3
Skilled persons
Unrestricted use
(public area)
B non possibile
C or E C and D, or E
C and D, or E C and D, or E
C and D, or E C and D, or E
G
B