Disposal Requirements Under Weee Regulations; During Installation; During Use; Service And Maintenance - Beijer Electronics X2 base 7 v2 HP Manual

1.3 Disposal Requirements Under
WEEE Regulations
For professional users in the European Union: If you wish to discard electrical
and electronic equipment (EEE), please contact your dealer or supplier for further
information.
For disposal in countries outside of the European Union: If you wish to discard
this product please contact your local authorities or dealer and ask for the correct
method of disposal.
1.4

During Installation

•
Install the operator panel according to the accompanying installation
instructions.
•
Ground the operator panel according to the accompanying installation
instructions.
•
Only qualified personnel may install the operator panel.
•
Separate the high voltage, signal, and supply cables.
•
Make sure that the voltage and polarity of the power source is correct before
connecting the operator panel to the power outlet.
•
Peripheral equipment must be appropriate for the application and location.
1.5

During Use

•
Keep the operator panel clean.
•
Emergency stop and other safety functions may not be controlled from the
operator panel.
•
Do not use excessive force or sharp objects when operating the touch screen.
1.6

Service and Maintenance

•
Only qualified personnel should carry out repairs.
•
The agreed warranty applies.
•
Before carrying out any cleaning or maintenance operations, disconnect the
equipment from the electrical supply.
•
Clean the display and surrounding front cover with a soft cloth and mild
detergent.
1.6.1
We recommend using a dry, clean cloth to wipe off dust regularly. Use alcohol or
ammonia-based cleaning agent for cleaning only when necessary. When other
solvents or cleaning agents are used, be sure to follow manufacturers' instructions.
The agent should be applied to a clean cloth and should not be sprayed directly
onto the panel surface. After cleaning the agent should be removed.
Ammonia based glass cleaners (typically 5-10% ammonia) or 75% alcohol can be
used to clean the surface of PCAP and resistive touch panels.
When you clean the surface of your touch panel, please follow these steps:
Beijer Electronics, MAEN330

Cleaning the Display

Safety Precautions
5