Gallagher T11 Mifare Reader Black Installation Note page 9

Gallagher PIV readers connect to the Gallagher Controller 6000 High Spec PIV (C305101) only.
An HBUS Reader connects to a Gallagher Controller 6000, Gallagher 4H/8H Module (attached to
a Controller 6000) or a Gallagher HBUS Door Module (connected to a Controller 6000).
A Cardax IV Reader connects to a Gallagher Controller 6000, Gallagher 4R/8R Module (attached
to a Controller 6000), Gallagher GBUS Universal Reader Interface (Gallagher GBUS URI), Gallagher
Controller 3000-8R or 3000-4R, Gallagher Local Bus Universal Reader Interface (Gallagher URI) or
a Gallagher Local Bus Reader I/O Interface.
HBUS Reader connection:
Note: To terminate an HBUS Reader, connect the Orange (HBUS Termination) wire to the Green
(HBUS A) wire.
Cardax IV Reader connection:
5. Fit the facia assembly into the bezel by clipping the small lip, into the top of the bezel and holding
the top, press the bottom of the facia assembly down into the bezel.
6. Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the
hole at the bottom of the bezel to secure the facia assembly.
Note: The Torx Post Security screw needs only to be lightly tightened.
3E4289 Gallagher T11 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Positive Red
Negative Black
HBUS Termination Orange
HBUS A Green
HBUS B Brown
CDXIV TX White
CDXIV RX Blue
Positive Red
Negative Black
HBUS Termination Orange
HBUS A Green
HBUS B Brown
CDXIV TX White
CDXIV RX Blue
Reader tail
Facia
Fit screw to secure facia to bezel
HBUS Reader terminated:
Positive
Negative
HBUS Termination Orange
HBUS A
HBUS B
CDXIV TX
CDXIV RX
Building cable
Connection
Red
Black
Green
Brown
White
Blue
Page 9