Zephyr ZMD-M90BS Use, Care And Installation Manual page 9

Table of Contents

Advertisement

Available languages

Available languages

ZEPHYRONLINE.COM
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician
determine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly
grounded branch circuit protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring
must be 2 wire with ground. Please also refer to Electrical Diagram on product.
A cable locking connector (not supplied) might also be required by local codes. Check with local
requirements, purchase and install appropriate connector if necessary.
* National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
Prop. 65 Warning for California Residents: This product may
Modena Island Use, Care, and Installation Guide
READ AND SAVE THESE INSTRUCTIONS
WARNING
contain chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Safety Information
9

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZMD-M90BS and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Zmd-e42bs

Table of Contents