Tx Port Settings - Victron energy BlueSolar 100/30 Manual

MPPT solar charger manual
(minutes) (minutes) (minutes)
• The degree of shift = time of sunset + half the duration of night - length of day = 1140m + 342m - 1440m =
42 minutes.
Example configuration
The selections which have been made on above screen image results in this program:
• At sunset - the light will be switched on for a fixed time
• Dim level at sunset - at Full brightness (100%)
• Keep lights on during - the duration has been set to 1h 0m
• Dim level at end - at the end of one hour the brilliance will be reduced to half (50%)
Also:
• At sunrise - the lighting will be adjusted before sunrise
• Time before sunrise - at 1h 0m before sunrise, the following adjustment will be made:
• Dim level - full brilliance will be restored (100%)

5.2.4. TX port settings

The VE.Direct-TX port can be used to send a signal to an external device. For example to send a PWM signal to dim a streetlight.
To use the TX port, a VE.Direct TX digital output cable is needed.
Page 24 Configuration and settings